Ls Control

Hygrostat in white fuga enclosure for wall mounting in rooms where ventilation should start/stop based on the air humidity.The humidity sensor gives a 230V outbut through a relay contact when humidity exceeds the set value. Operation is indicated on the front panel by a light. When humidity falls below set value the ventilator stops. The function can be inverted.

Luna is an innovative LED downlight, approved for directinstallation in insulation and flammable material.Due mounting with the help of screws and/or springs, aperfect result is guaranteed – every time!The mounting height of only 33 mm makes it possible tomount Luna in most places.The replaceable LED light source makes the installationflexible and future-proof – for example, if you want a differentcolor temperature.It is possible to mount with cable or 16 mm flexible tube.

SpeedControl 15 WSE - Triac controller for fan motors, iron core transformers or incandescent lamps. With built in rotary switch and on/off diode indicator lamp. The controller is mounted in plastic base, and it is designed for use with LK Fuga and can be fitted together with standard Fuga fitting components. The controller is equipped with a trimmer for adjustment of the minimum speed of the motor. It is recommended to connect a coupling resistor to transformers with a high initial current. The adjustment principle is leading edge.

SpeedControl 35 W - Triac controller for adjustment of single phase ventilation motors and adjustment of incandescent lamps and iron core transformers.The controller is mounted on a plastic base but can also be built into a suitable type of enclosure.The SpeedControl 35 is equipped with on/off indicator lamp, rotary switch and adjustable minimum voltage. The SpeedControl is also available in a spray proof version (IP 54).

Hose pipe for mounting on ventilation duct. Fitted with two screws on the duct.

Cira is a adjustable LED downlight with a low mountingheight and good light properties. Cira is approved for installationdirectly in insulation and flammable material.The mounting height of only 38 mm (45 mm when adjustedto max) ensures many applications.Large front/cover ensures a nice result at a cutout from68 mm to 74 mm.Quick mounting in the attached connection box with minimaltool utilization.Detachable front ring, ensures flexibility if you want a differentcolor and when painting.

The CO2 sensor is a combined sensor and regulator for a wide range of applications. For full control of ventilation in offices and/or as CO2 sensor in more complicated ventilation systems.It is provided with two independent 0-10V outputs. A proportional output based on the current CO2 level, and one control output designed for control of damper or ventilation plant. Room temperature can be included as a control parameter. Also available with integrated MODBUS communication protocol for retrieval of data from the unit - product no. 48305.Both design and ease-of-use have been prioritisedEasy to set-up, install and adjust.Maintenance free.Discreet sensor ideal for mounting in households and office environments. Control of ventilation plant based on temperature and CO2 level.Possible to adjust on the basis of CO2 level alone.Possible to use as CO2 meter and ventilation controller simultaneously.PID (proportional-integral-derivative) adjustmentTwo output control signal ranges available: 0 - 10V or 2 - 10V.If on/off operation is required, the set point relays 41204 or 41210 can be used together with the sensor. 24VDC power supply available for supply of one CO2 sensor box.If on/off operation is required, the 24V DC power supply type PowerSupply 0.1-24 E with integrated setpoint relay is ideal to use together with the sensor.